To use Advance Mode, do the following steps:
1. Click the Advance Mode radio button.
2. Click Index 1 to access into the following page.
Available settings are explained as follows:
Item Description
Check to enable the
Filter Rule
Check this box to enable the filter rule.
Comments Enter filter set comments/description. Maximum length is
14- character long.
Index(1-15) Set PCs on LAN to work at certain time interval only. You
may choose up to 4 schedules out of the 15 schedules
pre-defined in Applications >> Schedule setup. The
default setting of this field is blank and the function will
always work.
Clear sessions when
schedule ON
Check this box to clear the sessions when the above
schedule profiles are applied.
Direction Set the direction of packet flow. It is for Data Filter only.
For the Call Filter, this setting is not available since Call
Filter is only applied to outgoing traffic.
To Next Page
Loading...
Need help?
General
