Vigor2133 Series User’s Guide
353
V
V
I
I
-
-
2
2
-
-
2
2
B
B
a
a
n
n
d
d
w
w
i
i
d
d
t
t
h
h
L
L
i
i
m
m
i
i
t
t
In the Bandwidth Management menu, click Bandwidth Limit to open the web page.
To activate the function of limit bandwidth for IPv4 and /or IPv6, simply click Enable and set
the default upstream and downstream limit.
Available settings are explained as follows:
Item Description
Bandwidth Limit Enable - Click this button to activate the function of limit
bandwidth.
IP Routed Subnet – Check this box to apply the bandwidth
limit to the second subnet specified in LAN>>General Setup.
It is available for IPv4 settings only.
Disable - Click this button to close the function of limit
bandwidth.
Default TX limit Per User- Define the default speed of the
upstream for each computer in LAN.
Default RX limit Per User- Define the default speed of the
downstream for each computer in LAN.
Limitation List Display a list of specific limitations that you set on this web
page.
Specific Limitation Start IP - Define the start IP address for limit bandwidth.
To Next Page
Loading...
