V
V
I
I
-
-
4
4
-
-
5
5
L
L
o
o
a
a
d
d
B
B
a
a
l
l
a
a
n
n
c
c
e
e
The parameters configured for Load Balance can help to distribute the traffic for all of the
access points registered to Vigor router. Thus, the bandwidth will not be occupied by certain
access points.
Available settings are explained as follows:
Item Description
AP Load Balance It is used to determine the operation mode when the system
detects overload between access points.
Disable – Disable the function of AP load balance.
By Station Number –The operation of load balance will be
executed based on the station number configured in this page.
It is used to limit the allowed number for the station
connecting to the access point. The purpose is to prevent lots
of stations connecting to access point at the same time and
causing traffic unbalanced. Please define the required station
number for WLAN (2.4GHz) and WLAN (5GHz) separately.
By Traffic – The operation of load balance will executed
according to the traffic configuration in this page.
By Station Number or Traffic - The operation of load balance
will be executed based on the station number or the traffic
configuration.
Station Number
Threshold
Set the number of stations as a threshold to activate AP load
balance.
Traffic Threshold Upload Limit –Use the drop down list to specify the traffic
limit for uploading.
Download Limit – Use the drop down list to specify the traffic
limit for downloading.
Action When Threshold
Exceeded
Stop accepting new connections – When the number of
stations or the traffic reaches the threshold defined in this
To Next Page
Loading...
Need help?
General
