option to turn off the LEDs after the specified number
of minutes.
When sleep mode is enabled, LEDs can be woken up by
pressing either the Wireless LAN ON/OFF/WPS button
or the Factory Reset button on the front panel, or by
clicking the Wake up LED button on this page. When
LEDs are lit, they can be put to sleep by briefly pressing
the Factory Reset button, or by clicking the LED sleep
immediately button on this page.
Status Shows the status of the LEDs. Such field will be displayed
after clicking Enable LED, Enable Sleep Mode and clicking
OK. Later, the LED Sleep immediately will be shown on the
page first.
– LEDs are in sleep
mode. To wake them up, do one of the following:
press the Wake up LED button on this page
press the Wireless On/Off/WPS button on the front
panel
press the Factory Reset button on the front panel.
– LEDs are awake. To put them to sleep immediately.
press the LED sleep immediately button on this page.
press the Factory Reset button on the front panel for 1
second.
After finished the above settings, click OK to save the configuration.
F
F
o
o
r
r
B
B
u
u
t
t
t
t
o
o
n
n
The Factory Reset and Wireless ON/OFF/WPS buttons on the front panel are enabled by
default and can be enabled or disabled if required. Disabling the Factory Reset button will
prevent tampering by unauthorized parties, or to avoid accidental triggering of a router reset
when being used wake up LEDs. Disabling the wireless button will prevent changing the
wireless setting when LED Sleep Mode is enabled, and the buttons are primarily used to turn
the LEDs on and off.
Click the Button tab to get the following page.
To Next Page
Loading...
Need help?
General
