Draytek Vigor2133 - Page 541

Vigor2133 Series User’s Guide
52
9
Parameter Description
server It means the dhcp server settings.
[<command>
<parameter>|…]
The available commands with parameters are listed below.
[…] means that you can type in several commands in one line.
-a It means to show current DHCPv6 status.
-b It means to show current DHCPv6 IP Assignment Table.
-n <name> It means to set a profile name.
-c<parameter> It means to send rapid commit to server.
1: Enable
0: Disable
-e<parameter> It means to enable or disable the DHCPv6 server.
1: Enable
0: Disable
-t <time> It means to set prefer lifetime.
-y <time> It means to set valid lifetime.
-u <time> It means to set T1 time.
-o <time> It means to set T2 time.
-i<pool_min_addr> It means to set the start IPv6 address of the address pool.
-x<pool_max_addr> It means to set the end IPv6 address of the address pool.
-r <1/0> It means to enable (1) or disable (0) auto_range.
-d<addr> It means to set the first DNS IPv6 address.
-D<addr> It means to set the second DNS IPv6 address.
-m<1/0> It means to enable(1) or disable (0) the server DUID set by Link
Layter and Time.
-q It means to set DNS domain search list.
-z<1/0> It means enable (1) or disable (0) the DHCP PD.
pdadd
<suffix><prefix_len><client
linklocal><client DUID>
It means to add PD node.
pddel <PD index> It means to delete PD node.
-A <parameter> It means to set authentication protocol.
0: Undefine
2: delayed protocol
3: Reconfigure key
- M <parameter> It means to set realm value (max: 31 characters) in delayed
protocol.
-S <parameter> It means to set shared secret (max: 31 characters) in delayed
protocol.
-K <parameter> It means to set key ID (1~65535) in delayed protocol.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> ip6 dhcp server -d FF02::1
> ip6 dhcp server -i ff02::1
> ip6 dhcp server -x ff02::3
> ip6 dhcp server -a
% Interface LAN has following DHCPv6 server settings: