Draytek Vigor2133 - Page 543

Vigor2133 Series User’s Guide
531
-p <prefix> It means to set 6in4 LAN Routed Prefix.
-l n It means to set 6in4 LAN Routed Prefix length.
-T n It means to set 6in4 Tunnel TTL.
TSPC/AICCU
-u <username> It means to set Username (max. 63 characters).
-P <password> It means to set Password (max. 63 characters).
-s <server> It means to set Tunnel Server IP.
<server>= IPv4 Addr or URL (max. 63 characters)
AICCU
-p <prefix> It means to set Subnet Prefix (AICCU).
-l n It means to set Subnet Prefix length (AICCU).
-o It means to set AICCU always on. On = 1, Off = 0.
-f It means to set AICCU tunnel ID.
Static
-w <addr> It means to set Default Gateway.
Others
-d <server> It means to set 1st DNS Server IP.
<server>= IPv6 Addr
-D <server> It means to set 2nd DNS Server IP.
<server>= IPv6 Addr
-t <dhcp/ra/none> It means to set ipv6 PPP WAN test mode for DHCP or RA.
-V It means to view IPv6 Internet Access Profile.
-k It means to dial the Tunnel on the WAN.
-j It means to drop the Tunnel on the WAN.
-r n It means to set Prefix State Machine RA timeout.
-c n It means to set Prefix State Machine DHCPv6 Client timeout.
-q It means to set WAN detection mode (0:NS Detect, 1:Ping Detect,
2:Always On).
-z It means to set Ping Detect TTL (0-255).
-x It means to set Ping Detect Host (hostname or IPv6 address).
-i It means to set ipv6 connection interval (1500-60000 (unit:10ms)).
-b It means to enable DNSv6 based on DHCPv6. On = 1, Off = 0
-R It means to Enable RIPng. On = 1, Off = 0
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> ip6 internet -W 2 -M 2 -u 88886666 -p draytek123456 –s amsterdam.freenet6.net
This setting will take effect after rebooting.
Please use "sys reboot" command to reboot the router.
> system reboot