Draytek Vigor2133 - Page 552

Vigor2133 Series User’s Guide
540
-E n
It means to delete an extension WAN.
n: 1: WAN1 ,2: WAN2, ... x: WANx.
-b map
It means to set bit map(decimal) for extension WAN.
map:
bit 0: WAN1
bit 1: WAN2, ... bit n: WAN(n+1).
-f n
It means to disable IPv6.
n= 1: Disable IPv6,
n=0: Enable IPv6.
-R n
It means to enable /disable RIPng.
n=1: Enable RIPng,
n=0: Disable RIPng.
-s n
It means to show IPv6 LAN setting.
n=0:show all. Default is show all.
n=1: LAN1
n=2: LAN2, ... 4: LAN4,
n=5: DMZ.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> ip6 lan -l 1 -w 1 -d 2001:4860:4860::8888 -o 1 -f 0 -s 2
% Set primary WAN1!
% Set 1st DNS server 2001:4860:4860::8888
% Set Other Option Enable!
% [LAN1] support ipv6!
This setting will take effect after rebooting.
Please use "sys reboot" command to reboot the router.
% [LAN2] setting:
% Primary WAN : WAN1
% Management : SLAAC
% Other Option : Disable
% WAN Exten : None
% Subnet ID : 2
% Static IP(0) : ::/0
% [ifno: 0, enable: 0]
% Static IP(1) : ::/0
% [ifno: 0, enable: 0]
% Static IP(2) : ::/0
% [ifno: 0, enable: 0]
% Static IP(3) : ::/0
% [ifno: 0, enable: 0]
% DNS1 : 2001:4860:4860::8888
% DNS2 : 2001:4860:4860::8844