<obj> – indicates index number of object or index number of group.
Available settings range from 1-96. For example, “-S 0 1" means the
first service type object profile.
-S u <protocol>
<source_port__value>
<destination_port_vale>
It means to configure advanced settings for Service Type, such as
protocol and port range.
u – it means “user defined”.
<protocol> – It means TCP(6),UDP(17), TCP/UDP(255).
<source_port__value> –
1 – Port OP, range is 0-3. 0:= =, 1:!=, 2:>, 3:<
3 – Port range of the Start Port Number, range is
1-65535.
5 – Port range of the End Port Number, range is 1-65535.
<destination_port_value>:
2 – Port OP, range is 0-3, 0:==, 1:!=, 2:>, 3:<
4 – Port range of the Start Port Number, range is
1-65535.
6 – Port range of the End Port Number, range is 1-65535.
-f <value> It means to set the gragment type.
0 – Don’t care
1 – Unfragmented
2 – Fragmented
3 – Too Short
-F It means the Filter action you can specify.
0 –Pass Immediately,
1 – Block Immediately,
2 – Pass if no further match,
3 – Block if no further match.
-m <value> It means to set the MAC Bind IP type.
0 – Non-Strict
1 – Strict
-L <value> It means to set number of sessions control.
0 ~ 30000
-q <value> It means the classification for QoS.
1– Class 1,
2 – Class 2,
3 – Class 3,
4 – Other
-l <wan><log flag> It means load balance policy.
Such function is used for “debug” only.
-E <value> It means to enable APP Enforcement.
1 - Enable
0 - Disable
-a<index><log flag> It means to specify which APP Enforcement profile will be applied.
To Next Page
Loading...
