Remote Endpoint IPv4
Address
Type the static IPv4 address for the remote server.
6in4 IPv6 Address Type the static IPv6 address for IPv4 tunnel with the value
for prefix length.
LAN Routed Prefix Type the static IPv6 address for LAN routing with the value
for prefix length.
Tunnel TTL Type the number for the data lifetime in tunnel.
WAN Connection
Detection
Such function allows you to verify whether network
connection is alive or not through Ping Detect.
Mode – Choose Always On or Ping Detect for the system to
execute for WAN detection. Always On means no detection
will be executed. The network connection will be on
always.
Ping IP/Hostname – If you choose Ping Detect as
detection mode, you have to type IP address in this field
for pinging.
TTL (Time to Live) –If you choose Ping Detect as
detection mode, you have to type TTL value.
After finished the above settings, click OK to save the settings.
Below shows an example for successful IPv6 connection based on 6in4 Static Tunnel mode.
To Next Page
Loading...
Need help?
General
