I
I
I
I
-
-
2
2
-
-
1
1
-
-
1
1
D
D
e
e
t
t
a
a
i
i
l
l
s
s
P
P
a
a
g
g
e
e
f
f
o
o
r
r
L
L
A
A
N
N
1
1
–
–
E
E
t
t
h
h
e
e
r
r
n
n
e
e
t
t
T
T
C
C
P
P
/
/
I
I
P
P
a
a
n
n
d
d
D
D
H
H
C
C
P
P
S
S
e
e
t
t
u
u
p
p
There are two configuration pages for LAN1, Ethernet TCP/IP and DHCP Setup (based on IPv4)
and IPv6 Setup. Click the tab for each type and refer to the following explanations for
detailed information.
Available settings are explained as follows:
Item Description
Network Configuration For NAT Usage,
IP Address - This is the IP address of the router. (Default:
192.168.1.1).
Subnet Mask - The subnet mask, together with the IP Address
field, indicates the maximum number of clients allowed on
the subnet. (Default: 255.255.255.0/ 24).
RIP Protocol Control,
Enable – When Enabled, the router will attempt to exchange
routing information with neighbouring routers using the
Routing Information Protocol.
DHCP Server
Configuration
DHCP stands for Dynamic Host Configuration Protocol. The
router by factory default acts a DHCP server for your network
so it automatically dispatches related IP settings to any local
user configured as a DHCP client. It is highly recommended
that you leave the router enabled as a DHCP server if you do
not have a DHCP server for your network.
If you want to use another DHCP server in the network other
than the Vigor Router’s, you can let Relay Agent help you to
redirect the DHCP request to the specified location.
Disable Server – Let you manually assign IP address to every
host in the LAN.
Enable Server - Let the router assign IP address to every host
in the LAN.
Start IP Address - The beginning LAN IP address that is
given out to LAN DHCP clients.
IP Pool Counts - The maximum number of IP addresses
to be handed out by DHCP. The default value is 200.
Valid range is between 1 and 253. The actual number of
IP addresses available for assignment is the IP Pool
To Next Page
Loading...
Need help?
General
