12
Click OK on t hat page t o apply t he changes.
3. Go t o [WAN] > [Internet Access]
Set t he WAN1 Access Mode t o PPPoE / PPPoA, t hen click t he Details Page
but t on t o proceed:
4. On t he PPPoE / PPPoA set t ings t ab:
Select t he Enable radio but t on at t he t op of t he page t o ensure t hat t he PPPoE
int erf ace is enabled.
In t he ISP Access Setup sect ion, input t he ISP username int o t he Username f ield
and password in t he Password field.
If your ISP has provided a st at ic IP address, t hat can be specif ied by set t ing t he
Fixed IP set t ing t o Yes and ent ering t he IP in t he Fixed IP Address field.
To Next Page
Loading...
