10
Introduction
Welcome to the world of Dremel Digilab. Our
mission is to mentor you through the 3D
building process and share best practices for
bringing your ideas to life.
3D building is a process that will involve
experimentation and persistence. Thankfully,
the Dremel experts are here to make your
job easier with online tips and live support.
Dremel 3D40 brings new functionality to
Dremel3D such as network connectivity and
remote printing. To get started with 3D40
follow the initial setup routine on the touch
screen.
You can create a user profile by going to
www.digilab.dremel.com. Your profile gives
you access to high-quality models, support
and software downloads, and remote printing
services. Once setup and registration is
complete you are ready to start building.
WIFI A local area wireless networking technology that allow electronic devices to
communicate.
X-Axis Guide Rails A set of rails on either side of the extruder that allow a stepper motor to move the
extruder to the left or right side of the build area.
Y-Axis Guide Rails A set of rails on either side of the build area that allow a stepper motor to move the
extruder to the front or back of the build area.
Z-Axis Guide Rails A set of rails located at the back of the build area that allow a stepper motor to move
the build plate up or down.
Glossary of Terms
To Next Page
Loading...
Need help?
General
