25
Observe all provided
warnings and safety
instructions when using the Dremel 3D40.
Failure to do so may result in fire, equipment
damage, property damage or personal injury.
Do not touch the
extruder tip during
operation or until it has cooled down to at
least 60°C (140°F). Contact with the extruder
tip during or after operation before tip has
cooled may result in personal injury.
Use only DREMEL
filament. Use of
filament not authorized by Dremel may result
in equipment and property damage.
Do not pull the
filament out. Doing so
may damage the extruder.
LOADING/CHANGING FILAMENT
1. Start filament load/change process by
tapping “Filament” button on touch screen.
Extruder will move to front right corner of
print area and extruder tip will begin to
heat.
2. After extruder stops moving, open the
3D40 Lid for better access to extruder.
3. If existing filament is loaded, cut existing
filament near extruder intake and tap
“Next” button on touch screen.
4. Remove Spool door by rotating it counter
clockwise and remove existing spool if
one is present, see figure 8.
Getting Ready to Build
To Next Page
Loading...
Need help?
General
