Dremel 3D40 FLEX User Manual

2
Safety Symbols....................................................................................2
General Safety Warnings..................................................................3-5
Symbols ...............................................................................................5
Dremel Remote Services.....................................................................5
FCC Compliance .................................................................................6
Information on Intellectual Property .....................................................6
Specifications.......................................................................................7
Resources............................................................................................8
Glossary of Terms...........................................................................8-10
Introduction ........................................................................................10
Kit Contents .......................................................................................11
Unpacking..........................................................................................12
Getting To Know Your Dremel 3D40 FLEX...................................13-14
Initial Setup...................................................................................15-17
Touch Screen................................................................................18-24
Dremel Digilab 3D Slicer Software ....................................................24
Getting Ready to Build..................................................................25-28
Building.........................................................................................29-30
Removing Your Object .......................................................................31
Dremel Cloud Platform ......................................................................32
Best Practices....................................................................................33
Maintenance .................................................................................33-34
Troubleshooting............................................................................35-36
Firmware and Open Source Software ...............................................37
Dremel
®
Consumer Limited Warranty ................................................38
Table of Contents
Safety Symbols
The definitions below describe the level of severity for each signal word. Please read the
manual and pay attention to these symbols.
!
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that follow this
symbol to avoid possible injury or death.
DANGER indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION indicates a hazardous situation which, if not avoided, could
result in minor or moderate injury.
DM 2610039151 10-18.qxp_3D40 10/8/18 10:34 AM Page 2

Dremel 3D40 FLEX Specifications

General

Brand	Dremel
Model	3D40 FLEX
Category	3D Printers
Language	English