Dri-Eaz BD2500 - User Settings Details; Job Hours and Maintenance Timers; Humidistat Control Settings; Temperature Units and Language Selection

07-01900G F413-230V AU BD2500 4 Legend Brands Holdings Ltd.
USER SETTINGS
Only menu items followed by a greater-than symbol (>) can be adjusted. If no keys are selected for 5 minutes on screens: INLET OUT-
LET, GRAIN DPR (INLET-OUTLET for 230V models), the display will return to normal display mode. In all the other menu items, the
display with return to the normal display mode after 20 seconds. Items without the symbol (>) are for information only and cannot be
changed or reset. See “System Messages” below for additional system status messages.
Press DISPLAY
MENU to proceed to
the next menu item. ↓
Press ˃ MENU SELECTION to change the setting.
→
□
1. JOB HRS RESET >
PWR INTERRUPT X
˃
1. JOB HR RESET 0
PWR INTERRUPT 0
Press ˃ to reset to 0.
2. INLET OUTLET
100ʹ 80% 115ʹ 30%
For information only.
3. GRAIN DPR
XX GPP
Unit displays GPP if set to Fahrenheit or g/kg if set to Celsius. To change this setting, see menu item 9.
4. FILTER CHECKED
XXX HRS >
˃
4. FILTER CHECKED
0 HRS
Press ˃ to clear filter hours.
5. COIL CLEANED
XXX HRS >
˃
5. COIL CLEANED
0 HRS
Press ˃ to clear coil hours.
6. HUMIDISTAT
MODE OFF >
˃
6. HUMIDISTAT
MODE ON >
Press ˃ to turn ON or OFF. For maximum dehumidification, make sure HUMID-
ISTAT is OFF.
7. HUMIDISTAT
SETPOINT XX% >
˃ Press ˃ to cycle through 40%–90% at 5% increments (default is 50%).
8. LANGUAGE
ENGLISH >
˃
8. IDIOMA
ESPANOL >
˃
8. SPRACHE
DEUTSCH >
˃
8. LANGUE
FRANCAIS >
Press ˃ to change lan-
guage options.
9. TEMP UNITS
ʹF >
˃
9. TEMP UNITS
ʹC >
Press ˃ to change to °F or °C.
10. COIL TEMP
XXʹ
For information only.
11. COMP CURRENT
XX.X A
For information only.
12. FIRMWARE
3.XX FXXX-XXX
For information only.
13. LIFE HOURS
XXXX HRS
(Returns to
top menu item.)
The following section available only on wireless-equipped units.
14. SENSOR ID
XXXXXXXXX
(Returns to
top menu item.)