Need help?Do you have a question about the DriSteem XTP 003 and is the answer not in the manual?
General| Brand | DriSteem |
|---|---|
| Model | XTP 003 |
| Category | Humidifier |
| Language | English |
Provides critical safety warnings for installers and general instructions to prevent injury or damage.
Details dangers of hot surfaces, water, and electrical hazards requiring specific procedures.
Emphasizes avoiding electrical shock by following shutdown and wiring safety protocols.
Covers safe steam piping practices and warnings about excessive water pressure to prevent system damage.
Provides a table detailing electrical current requirements and recommended fuse sizes for XT Series models.
Provides guidelines for choosing an appropriate installation location, considering proximity and environmental factors.
Shows diagram and specifies minimum clearances required around the XT Series humidifier for installation.
Details the mounting keyhole locations and dimensions for XT Series humidifiers by model.
Step-by-step instructions for safely removing the steam cylinder from the humidifier.
Instructions for securely mounting the humidifier to a wall, including wood stud wall mounting.
Details code requirements, air gap, grounding, and tempering for drain piping.
Covers general wiring requirements, conduit knockouts, and component placement considerations.
Provides instructions for control signal wiring, input wiring, and remote signal wiring.
Explains the impact of sensor location on humidifier performance and lists ideal/acceptable locations.
Explains the process of humidity control, electrode operation, and steam production.
Lists essential checks for installation, wiring, and connections before powering up the humidifier.
Step-by-step guide for starting up the Model XTP humidifier after installation.
Outlines routine inspection points for cylinder, valves, hoses, and electrical components.
Provides critical steps to safely cool down the humidifier before performing maintenance.
Detailed instructions for removing and replacing the steam cylinder, including electrical and hose connections.
Step-by-step guide for maintaining the drain valve body, including disassembly and cleaning.
Procedures to resolve issues with the drain valve assembly if initial maintenance fails.
Introduces the troubleshooting process for Model XTP humidifiers, including test modes and support contact.
Lists causes and actions for when the humidifier fails to power on.
Details the terms, conditions, exclusions, and limitations of the limited warranty.
To Next Page
