EasyManua.ls Logo

Drivecon XT Series - Examination before installation and Purchase history

Drivecon XT Series
57 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Owner's Manual
Drivecon Toll Free Ph: 1-800-374-8266
Drivecon reserves the right to alter or amend the above information without notice
Examination before installation and purchase history
Every Drivecon inverter has been fully tested and examined before shipment. Please carry out
the following examination procedure after unpacking your inverter.
Verify that the inverter model number is the same as the one you ordered.
Check to see if there is any damage that may have occured during transit. Do not connect
the inverter to the power supply if there is any sign of damage. Report to regional sales
representative or Drivecon if you find any abnormal conditions as mentioned above.
Caution!
Failure to inspect the inverter may lead to damage of the system and possible down time. Should
you find any reason to suspect the unit itself or any part of the system to be faulty please contact
Drivecon toll free at 800-374-8266 or 847-855-9150. Be prepared to provide model number of your
controller and any other pertinant information relative to the system.
Purchase history
Please take a moment and record the following information for future reference:
Model: _______________________
Serial number: _______________________
Date purchased: _______________________
Date installed: _______________________
Installed by: _______________________
Dealer: _______________________
WARRANTY
Seller warrants that all products manufactured by it to be free from defects in material and/or
workmanship under proper and normal use by the initial user for 24 months following the date of
shipment. Seller is the sole determinant of all claims under warranty, is not responsible, and will
not issue credit for defects and damage that arise from improper installation, neglect, improper
use, unauthorized repairs or alterations, or from normal wear and tear.
During the warranty period, Seller will repair or replace, FOB its plant, any parts reported and
found to be defective by its inspection. Seller will not assume any expenses or liability for any
work done on its equipment outside its plant without its written consent, and such unauthorized
work will automatically void Seller’s warranty.
Field labor and any related expenses are
not
covered under this warranty. A purchase order is
required for any and all field work.
This warranty is in lieu of all other warranties expressed or implied, including warranty of mer-
chantability of fitness for a particular use.
A-2

Other manuals for Drivecon XT Series