Owner's Manual
Drivecon Toll Free Ph: 1-800-374-8266
Drivecon reserves the right to alter or amend the above information without notice
When power is turned ON
WARNING!
• Do not attempt to install or remove the control panel connector to or from the
inverter when the power supply is turned on. Otherwise, the control panel may be
damaged due to surge peak caused by the insertion or removal.
Under Operation
WARNING!
• Do not switch the motor ON with a contactor connected to the inverter's output
while the inverter is operating, otherwise the inverter may be damaged.
• Do not remove the front cover of the inverter while the power is ON to avoid
personal injury caused by electrical shock.
• When the automatic restart function is enabled, the motor machinery will be
restarted automatically. Keep a safe distance to avoid personal injury. It is not
advisable to enable this function on any manually operated system.
• Do not use an input contactor to cycle inverter ON and OFF. Repeated cycling may
cause inverter damage.
CAUTION!
• Do not touch the heatsink base.
• The inverter can be easily operated from a low-speed to high-speed range. Please
confirm the operating range of the motor and the machinery you are controlling with
their respective manufacturers.
• Do not examine the signals of the PCB of the inverter when it is under operation.
• All inverters are properly adjusted and set by the factory prior to delivery. However,
every system may require minor adjustments to be complete at time of installation.
Do not exceed the specified limits of the equipment or inverter.
• Do not proceed with disassembly or examination procedure before ensuring that the
power is off and the Power LED extinguished.
• Dangerous voltages are stored within the inverter for up to 2 minutes after removal
of line power.
• Use caution when operating from the direct keypad mode as safety travel limits will
not function.
• Do not suspend or handle loads directly over people. Refer to ANSI B30.16 as to
safe crane operating procedures.
A-4
To Next Page
Loading...
