5
Section 3: Bell Follower Installation (Mode1)
3.1 Setup and Installation
3.1.1 Bell Follower Installation (Mode 1, TL250 Only)
Install the T-Link TL250 in a DSC enclosure (model PC5003C) when used in a Bell Follower
configuration. Refer to section [036][99]. Connect the + and - terminals to the external 12-
24Vdc power source.
NOTE: Bell Follower mode can not be used in UL or ULC listed installations.
Refer to options [062] through [065].
BELL+ BELL-
Alter nate connection fo r
Control P anels where Bell
sw itches High
Relay
Com
NC
NO
To Next Page
Loading...
