Installation
18
4 INSTALLATION
The DSE battery charger is fit-and-forget. It can be permanently connected to the supply and the load,
with no requirement to disable the charger during times of heavy load (such as engine cranking).
4.1 BATTERY SUITABILITY
The charger is factory set by DSE to suit Lead Acid batteries but can be adjusted to suit other battery
types using the Configuration Suite PC Software.
Care should be taken to ensure the batteries connected to the charger are of the correct ‘technology’
to suit the setting of the charger.
NOTE: Ensure any Standing Load (loads connected to the battery charger other than the
battery) are less 75% of the battery charger configured rating. This helps to ensure the charger
correctly detects the battery charge state.
To Next Page
Loading...
