ABS disabling function
This function disables or enables the ABS.
To access the function it is necessary to view the
"setting" menu page 73, use button (1) or (2) to select
the "ABS" function and press reset button (4) to go to
next page.
The function setting is highlighted on the display (ON
in green or OFF in yellow); use button (1) or (2) to shift
the arrow on the left onto the new setting and
confirm by keeping the reset button (4) pressed for 3
seconds.
After these 3 seconds the system checks whether
the request was actually complied with; during the
check the display will show the message "PLEASE
WAIT…".
The new condition will be displayed after check time.
Note
If the disabling request was not completed
successfully, repeat the procedure. If the problem
persists, contact a Ducati Dealer or Authorised
Service Centre.
To exit the setting function, press the reset button (4)
when "EXIT" is highlighted.
111
To Next Page
Loading...
