Duke TSC - Closing up Unit

11
Installation and Operation of: TSC - TSCM Retrot
CLOSING UP UNIT
Step 3
Place back panel on unit and secure with the
eighteen (18) screws. Tighten once all are started.
Step 4
Replace back electrical panel shield with three (3)
screws
INSTALL
INSTALL
Step 1
Install right side panel with screws. Replace false
bottom tray and shelving.
Step 6
Tilt up and slide back the control panel. Replace the
Top 2 screws and tighten all 8 screws on both sides.
NOTE: Verify wiring is not trapped, pinched or visible
under the controls panel after fully slid into position.
Install
Tighten
Step 8
Reconnect power or remove Lockout/Tagout on unit.
Step 9
Turn on unit and verify operation.
Step 7
Slide unit back into place.
Step 2
Clean any dirt or grime o the wire diagram on the
inside of the back cover. Peal backing o new wire
diagram and cover old diagram.
Step 5
In front control panel bundle any old unused wires
and secure inside control cavity.