Duke TSC - Installation of New Control Panel

6
Installation and Operation of: TSC - TSCM Retrot
INSTALLATION OF NEW PANEL
Step 1
Unpack new control making sure ESD protocol is
followed. Check for any damage.
Step 3
Using the two (2) Screws removed in step 7 of
removal install new panel.
NOTE: Do not tighten screws.
NOTICE:
More of the low voltage components are located on
the front panel.
Step 8
Remove two white wires from the left side of the
relay on the back wall of the control cavity. Cut re-
moved wires and discard.
REMOVAL OF OLD CONTROL PANEL  continued
Step 9
Remove two wires from the beeper in the upper left
corner of the control cavity.
Step 2
The control is shipped with a protection cover on the
back. This needs to be removed and discarded.
REMOVE
Back Panel
RELAY
CONNECTIONS
STEP 6
BEEPER
CONNECTIONS
STEP 5