EasyManua.ls Logo

Dulevo 100 elite - Page 64

Dulevo 100 elite
134 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
-4-
2010-04
20 / 24
Spazzatrice / Sweeper 100 Elite
4.4.d - LUCE DI CORTESIA
Lampada (10) a tre posizioni:
- Premuta da un lato, la luce è sempre accesa.
- Premuta dal lato opposto, la luce è sempre spenta.
- Posizionata al centro, la luce si accende all’apertura
delle portiere della cabina di guida.
4.4.e - AEREATORE
- Agire sull’interruttore a due posizioni (1) per attivare
la funzione di aereatore o pressurizzatore.
- Mediante l’interruttore (2), regolare la velocità del
ventilatore.
- Per arrestare la funzione, posizionare l’interruttore
(2) su “0”.
4.4.f - RISCALDAMENTO CABINA (BS-DK)
La macchina può disporre di un impianto per il riscalda-
mento della cabina; per mettere in funzione l’impianto
operare come segue:
- Aprire il rubinetto di mandata acqua calda (3).
- Abilitare il funzionamento della ventola del
riscaldatore mediante l’interruttore (4); si illumina la
relativa spia (4a).
- Orientare il getto di aria calda nella cabina tramite la
bocchetta (5).
- Per spegnere il riscaldamento, agire sull’interruttore
(4).
2
1
4a
4
3
5
4.4.d - COURTESY LAMP
Lamp (10) with three positions:
- When pressed to one side, the lamp is always on.
- When pressed to the other side, the lamp is always
off.
- When positioned in the middle, the lamp goes on
when the driver’s cab doors are opened.
4.4.e - AERATOR
- Act on the two positions switch (1) to activate the
function of the aerator or pressurize device.
- Adjust the fan speed by means of the switch (2).
- Place the switch (2) on “0” to stop the function.
4.4.f - CAB HEATING (BS-DK)
The machine can dispose of a cab heating installation;
to activate the installation proceed as follows:
- Open the hot water forcing tap (3).
- Enable the function of the heating fan by means of
switch (4); the related indicator lamp will light on (4a).
- Direct the hot water jet in the cab by means of the
opening (5).
- Act on the switch (4) to switch off the heating.

Table of Contents

Related product manuals