Printed in Germany / M-MT-BOS
• Edition 11.99 • # 231 763
52 … 112
The controller automatically goes to standby status if the automatic burner-
control system has not been programmed. In the unprogrammed state, the
automatic burner-control system remains on standby. Unprogrammed means
that the working point has not been fully programmed.
Once valid working points have been programmed and the automatic burner-
control system detects the presence of the corresponding components when
it starts up, the burner starts as soon as the control chain and GWmax are
closed.
If progamming has been completed and you want to correct points such as
the ignition load P0, low load P1 or high load P9 in operation, press the "+"
and "-" buttons simultaneously to access setup mode.
Simultaneously press the "1" and "2" buttons if you want to enter the full setup
mode. The "P" symbol always appears in the display to indicate that setup
mode is activated. If you do not press a button in setup mode before the
timeout expires, setup mode is exited automatically and a RESTART is
performed.
Setup mode
Gas firing, pneumatic
modulation
■ The burner must be in standby
status, otherwise you cannot
access the setup mode
■ Changing points defined before-
hand
■ Accessing setup mode
To Next Page
Loading...
Need help?
General
