23
6. OPERATING
6-2. Using Connected to the DFC-10/12
Set the paper size and binding method, etc. on the DFC-10/12.
For details of the settings, refer to the DFC-10/12 instruction manual.
1
Press the preset key on the control panel of the DFC-10/12. Test operations will start.
One set from the DFC-10/12 is ejected to the side-stapled paper stacker.
Follow the DFC-10/12 instruction manual and check the number, etc. of set of paper.
Paper stapling and folding operations are not performed during test operations.
2
Booklet A4 6
Operating
Message
Output mode (Through/Fold/Booklet/Side ST/Corner ST)
Paper size
(A3/A4/A5/B4/B5/LGR/LGL/LTR/IV/Cust.1/Cust.2/
Cust.3/A3SR)
Number of sheets
(for one set)
Check the binding condition, and adjust as follows if necessary.
Setting the paper guide roller position
Refer to “5-3. Setting the Position of the Paper Guide Roller”.
To adjust the stapling and folding positions, and paper alignment
Refer to “7. FINE-ADJUSTING PAPER ALIGNMENT, STAPLING AND FOLDING POSITIONS”.
Press the start key on the control panel of
the DFC-10/12 to bind 1 set, and then
press the stop key.
Continuously bind the number of required sets on the DFC-10/12.
NOTE : For details of the DFC-10/12 operations, refer to the instruction manual for the DFC-10/12.
3
4
5
To Next Page
Loading...
