xv
Chapter 1
Contents
Introduction
...........................................................................
i
Notes on Safety (Please Read and Observe)
.................................
iv
Safety Precautions
.............................................................
iv
Locations of Safety Labels
...................................................
viii
Label of High-Voltage Warning
................................................
x
Location of Rating Labels
.....................................................
xi
Emergency Stop Function
....................................................
xii
Interlock System for Safety
..................................................
xiii
Before Using This Machine
Part Names and Their Functions
..................................................
2
Appearance
......................................................................
2
Appearance (Ejection Side)
...................................................
3
Inside
..............................................................................
4
Creaser Module
.................................................................
5
Cutter Module
...................................................................
6
Slitter Module
....................................................................
7
Control Panel
....................................................................
8
Turning Power ON/OFF
.............................................................
9
Turning Power ON
..............................................................
9
Turning Power OFF
............................................................
9
Preparation Before Use
............................................................
10
Loading Documents
...........................................................
10
Adjusting the Elevator Height (Feed Tray)
................................
12
Adjusting the Air Amount
.....................................................
12
Adjusting the Height of the Separator
......................................
12
Skew Adjustment
..............................................................
13
Adjusting the Suction Skew
..................................................
14
Setting the Exit Tray
...........................................................
15
Attaching the Guide (Ejection Side)
........................................
16
Attaching the Card Stacker (Option)
.......................................
16
Replacing the Module in Slot 1
..............................................
19
Replacing the Module in Slot 2
..............................................
19
Slitter Modules
.......................................................................
21
Slitter Units
......................................................................
21
Removing the Slitter Units
...................................................
23
Attaching the Slitter Units
....................................................
25
How to Use the Gauge
........................................................
27
Attaching the Guide
...........................................................
30
Creaser Module
.....................................................................
31
Creaser Module
................................................................
31
Change Directions of the Creaser Tools (Upper/Lower)
................
32
Registration Mark
...................................................................
34
End Mark
.............................................................................
36
To Next Page
Loading...