Programming a JOB
67
Programming JOB
2
Settings-1
For the procedures of setting after this, follow steps
12 to 15 in Programming a JOB with Template.
(→ P.57)
-2%6HWWLQJV
$LU.QLIH
6XFWLRQ3RZHU
&XW7ULP0RGH
7UDLO&XW0RGH
5(*0DUN
)XOO%OHHG0RGH
$XWR
6(7
21
2))
21
2))
0$; 0,'
0,1
ڸ
ڸ
ڸ
ڸ
-2%&87
&87 PP
㸦㸧
6(7
㸦㸧
-2%&UHDVH6/27
PP&UHDVH
6(7
㸦㸧
-2%&UHDVH6/27
PP&UHDVH
6(7
● When the
cutter module
is set in the module 2
Enter the distance between the lead edge of a
document and the fi rst cut position.
Touch
SET
.
You can set up to 30 cut positions.
● When the creaser module is set in the module 2
Enter the distance between the lead edge of a
document and the fi rst crease position.
Touch
SET
.
You can set up to 20 creases.
If you fi nish the setting with fewer than 20 creases,
touch
SET
after entering the last crease position
and then touch
SET
again.
To Next Page
Loading...