Duplo DC-535 - Basic Operation Modes and Workflow; Understanding Operating Modes

- 15 -
4. Basic operation
About modes and mode displays
The DocuCutter has 4 modes. After completing the "Procedures for using the machine" (p.10), turn on
the power, select a registration number (in the Select mode), and perform test cutting. Then use the
RUN mode to run the machine.
* No cutting dimensions are registered when the machine is shipped. After turning the power on for
the first time, register cutting dimension data (in the Freesize Input mode) before running the
machine.
1
(Operation)
[Run mode] Mode for operation
aP.18
Testing
Press
Press
aP.18
Operation
MODE
qTest cutting (executed by pressing SET
button)
wOperation start (executed by pressing
START button)
¥ Operation stops when counter reaches
set quantity, or when STOP button is
pressed
¥ Use the RESET button to reset the
counter
¥ Use the button to move the paper
forward
¥ Use the button to move the paper
backward
2
(Selection)
[Select mode]
For selecting
registration number
aP.17
Selection
MODE
qSelection of registration No.
¥ No. Cut(side-margins-only cut)
¥ No. 00
¥ No. 98
(Use and buttons to select
number. Use F button to view registered
data.)
wConfirmation of selection
Press the SET button to confirm the
selection. "#", indicating "selected" will
be displayed.
[Run]
No.01: 3:T 307.0
[Select ] #
No.01: 3:T 307.0