Duplo DC-535 User Manual

- 17 -
4. Basic operation
Turning on the power1
Selecting the cutting dimensions2
1.
Press the [ ] side of the power switch, to turn the power
on. When the power is turned on, the screen that was
displayed when the power was last turned off appears on
the LCD panel.
1.
Press the MODE button as many times as needed to
select the SELECT mode.
2.
Use the "+" and "-" buttons to select a pre-registered
number.
Pre-register cutting dimensions, and call them up as
required by selecting registration numbers.
Numbers 0 through 98 are available for registering
cutting dimensions.
* To turn off the power:
Press the [ ] side of the power switch.
Note
¥ No dimensions are registered when the machine is
shipped. For the registration procedure, see "Registering
the cutting dimensions" below.
Note
¥ To view the registered data:
Press and hold down the F button. The registered cutting
data will be displayed sequentially.
DocuCu t t e r 535
Ver .
41
.
11
[Run]
No.01: 3:T 307.0
[Run]
No.01: 3:T 307.0
[Select ]
No.01: 3:T 307.0
[Select ]
No.01: 3:T 307.0
[Select ]
No.01: 1: 10.0mm
Power switch
ON
OFF
Registration No.
Sequential display
Number
of pieces
Total
Length
¡Screen displayed when power was last turned off

Duplo DC-535 Specifications

General

Brand	Duplo
Model	DC-535
Category	Cutter
Language	English