3-17
Chapter 3 ADVANCED OPERATION
Side guide
Side guide
Fixing screw
Fixing screw
6
After pressing the side guide to each
side of the paper lightly, tighten the
screws to secure the side guides.
Paper set lever
7
Lower the paper set lever.
The paper feed table will be raised.
Make sure that you lower the paper set
lever. If you start operations without the
paper set lever lowered, the paper feed
rings will run idle, causing the machine
to stop.
8
Press the Start button for test fold-
ing.
9
Press the Stop button after a couple
of folded sheets are ejected.
Test folded sample
10
Check the nish of test folding.
Check for folding misalignment using the
second test folded sample.
If folding misalignments occur, refer to
Chapter 3 "ADVANCED OPERATION"“5.
Correcting Folding Misalignment”
( p.3-27).
Clear button
11
After completing adjustments, press
the C (clear) button for more than
two seconds to clear the counter to
"0."
To Next Page
Loading...
Need help?
General
