Duplo DF-990A - Page 70

66
Chapter3AdvancedOperation
Copyright © 2019 Duplo Corporation All Rights Reserved
[1]
[1]
[7]
DF-999/DF-999A
When the DF ULTRASONIC SENSOR KIT is registered
When the DF ULTRASONIC SENSOR KIT is not registered
DF-990/DF-990A
[2]
[2]
[3]
[4]
[7]
[3]
[4]
[1]
[7]
[3]
[8]
[4]
[6]
[5]
[6]
[5]
[6]
[2]
[9]
[5]
No. Name Function Default
value
[1] OperMode Set the movement of the folding stopper for folding plate 1 and 2.
[Normal]:Whenthepoweristurnedon,themachinestartsupin
the normal setting state.
[LastFold]:Whenthepoweristurnedon,themachinestartsup
with the setting contents of the last time the machine was used
ineect.However,[Detection]startsupsetasturnedon,and
theadjustmentvalueoffoldingplate1and2returntotheinitial
value when not saved.
Aftersetting,anicon( )isdisplayedonthetouchpanel
display section.
[StopperFixed]:Thesettingsofthecontrolpanelcanbeomitted
when folding is always performed in the same conditions.
Whenthismodeisset,themachineisalwaysautomaticallyset
to the same conditions when the power is turned on and initial
operation of folding plate is no longer performed.
[StopperFixed]isautomaticallysettosameconditions,therefore
thefoldingmodeorpapersizecannotbechanged.
However,[Detection]startsupsetasturnedon.
Theadjustmentvalueoffoldingplate1and2returnstotheinitial
value when it is not saved.
Aftersetting,anicon( )isdisplayedonthetouchpanel
display section.
Normal
[2] D-Feed
“8-4. Double-feed detection” (p.63)
OFF
[3] Interval Sets whether to enable the interval.
O
[4] Processingspeedup/down
key
Chapter 1 “6-1-2. Touch panel operation section” (p.16)
Speed5