What to do if there is a jam in Sensor 2 of my Duplo Cutter?
If there is a jam in Sensor 2 of your Duplo Cutter, you can try the following: * Check S2. * Adjust the feed tray tension. * Adjust the ramp. * Check that the transport motor has detent torque.
Why is my Duplo Cutter miss feeding?
If your Duplo Cutter is miss feeding, you should check the S1 voltage, feed motor belt, pulley screw, and motor detent torque. If there is no torque, consider replacing the driver board.
General| Cutting Speed | Up to 40 cuts per minute |
|---|---|
| Power Supply | 120V, 60 Hz |
| Dimensions | 20.9" (L) x 17.3" (W) x 11.8" (H) |
| Weight | 44 lbs |
| Cutting Width | 228 mm |
| Maximum Cutting Width | 228 mm |
| Maximum Cutting Height | 15 sheets (80 g/m²) |
Information on the proper disposal of Waste Electrical and Electronic Equipment in Europe.
Defines symbols for substances, preparations, and components in WEEE.
Lists abbreviations for plastic categories used in the parts catalogue.
Lists all accessories provided with the DocuCutter CC-228 machine.
Identifies key components like Power Switch, Control Panel, and Feed Rollers.
Identifies additional components like Waste Bin, Stack Tray, and Slitter Module.
Details the keys and functions for both Simple and Advance control panels.
Explains the purpose of each key on the control panels.
Guides on inserting the waste bin and attaching the stacking tray.
Instructions for connecting the power cord and applying the control panel sticker.
Details how to adjust the paper width using the thumbscrew knob.
Explains paper preparation, loading, and adjusting tray pressure for different paper weights.
Presents 5 predefined jobs with descriptions, finished sizes, and layouts.
Illustrates the layout for business card and 3.5x5 card jobs.
Shows layouts for 8x4 and 7x5 card jobs, noting optional slitters.
Step-by-step guide on how to select a job using the control panel.
Explains how to use the batch count to automatically stop the machine.
How to enter program mode for user-defined jobs.
Steps to adjust finished length, top margin, and gutter length.
Explains the purpose and activation of the cut mark feature.
Details on using Turbo Mode and handling a full waste bin.
Instructions for resetting the counter and clearing paper jams.
Provides solutions for common error messages like 'Out of paper' and 'miss feed'.
Troubleshooting steps for cover, waste bin, and reset errors.
To Next Page
