DocuCutter 545
Paper Handling
Throughout the following paragraphs, you will be reading
about Slitters, a Cutter, and a Creaser. These
components are used in various combinations to finish
documents in the DocuCutter DC-545. Figure 13 is
provided below to help you understand the paper handling
terms associated with the DocuCutter DC-545.
You should note that, by definition, a cut or a crease is
perpendicular to the direction of paper feed, while a slit
is parallel to the paper feed direction.
Cut
PAPER FEEDING DIRECTION
Crease
REG Mark
(Optional)
Bar Code
(Optional)
Slit
Figure 13. Paper Handling Terms
22 DocuCutter 545 Training Guide © 2002, Duplo USA Corporation
To Next Page
Loading...
