DocuCutter 545
Safety
The objective of this section is to familiarize you with the
safety requirements related to the operation and servicing
of the DocuCutter DC-545. By reading this section, you
will gain an understanding of the important safety
information relating to this product.
NOTE One of the most important goals of this section is to give
you enough information so that you will always take the
proper safety precautions when servicing this product.
• At no time will you ever be instructed to come in
contact with internal drive components or high
voltage electrical devices that are under power. In
fact, the first step in most service procedures is -
“disconnect power cords.”
• At no time should you ever instruct an operator to
touch any moving or powered internal components.
• The only time that power is left on during a service
procedure is when specific components are being
tested.
All safety devices and covers should be in place and in
working order before completing a service call. It is your
responsibility to follow safe work procedures at all times. If
you perform an unapproved service procedure, you may
run the risk of injuring yourself or the people nearby. Also,
you could be inadvertently demonstrating a dangerous
service procedure to a customer. This could result in a
severe injury and an expensive lawsuit.
8 DocuCutter 545 Training Guide © 2002, Duplo USA Corporation
To Next Page
Loading...
Need help?
General
