189
6
Troubleshooting
Open the “front cover”.
Make sure the LED lights up.
If it is blinking, press the “drum removal button”.
Pull out the “drum unit” toward you while holding the
“drum release lever” until it comes to a stop.
When “MASTER EJECTION ERROR” is Displayed
● Do not press the surface of the drum unit with your fi ngers or scratch it.
Doing so will not only dirty your fi ngers or clothing but will also indent the drum unit surface,
preventing normal printing.
●
Before placing the drum unit, check the location for other objects so that it is placed on a level surface.
● Scratches or dents on the drum unit surface prevents normal printing.
●Do not touch the drum or rollers when
you operate the paper eject switch.
●Do not put your hands or fi ngers inside
the machine while it is operating. Your
hands may be pulled in or nipped.
When an old master remains on the drum, “MASTER EJECTION ERROR” is displayed on the
touch panel LCD. Remove it according to the following procedure below.
Drum removal button
Removing the Master Adhering to the Drum
Continue Page....
WARNING
WARNING
V3M0621
V3M0622
V3M0623
To Next Page
Loading...
Need help?
General