Troubleshooting
Reference
Table 5-1
Troubleshooting
reference
Problem
The engine
being jump-
started will not
start.
Possible Cause
Duracell® Powerpack
battery
is
not fully
charged.
The engine condition is
poor.
The engine start capacity
exceeds the Duracell®
Powerpack jump-start
capability.
Solution
Recharge the Duracell®
Powerpack battery.
Have the engine serviced.
Use a higher power Duracell®
Powerpack.
Thejump-start
clamps
measure zero
volts.
Jump-start powerswitch is Tum the jump-start power
OFF. switch ON.
Duracell® Powerpack
battery needs to be
recharged.
The
compressor
runs, but
won't
inflate.
-----------1------------------------1------------------------
The valve connector may Make sure the valve connector is
not be securely placed on securely placed on the valve
the valve stem. stem before closing the thumb
latch.
The item being inflated
may have a leak.
Make sure the item being
inflated doesn't have a leak.
Check the compressor hose for
any breaks or leaks.
The
compressor
runs slowly.
The compressor may have Tum offthe compressor and let it
overheated from excessive cool down.
use.
Battery voltage
is
too
low.
Check the condition
of
the
internal battery. The battery may
need to be recharged or replaced.
41
To Next Page
Loading...
Need help?
General
