DuraLabel.com | 800.788.5572
7.6 Recovering Templates | 15
ADVANCED FUNCTIONS
7.3 Installing Programs
The Toro cannot install or run user programs. Only manufacturer-supplied upgrades can
be installed. If you would like to use other software, you can use Toro as a desktop label
printer by connecting it to your computer. Plug a USB cable into the USB-B port on your
Toro and connect the other end to an available USB-A port on your computer. If your
Toro is equipped with the optional Ethernet port, you can also set up Toro as a network
printer.
Once you have installed the Toro printer driver on your computer, you will be able to use
many different programs to print labels.
7.4 Password Protection
To enable Toro’s password protection option, select the Programs menu from the
toolbar, highlight Password Control, and choose Add User. Complete the information in
the Add User window that appears, then click Enable Lock. The next time Toro is started
up (or wakes from its Sleep mode) a log-in prompt will be displayed.
The following are shown under Password Control:
• Add User
• Delete User
• Change Password
• Disable Station Lock (toggle – disable/enable)
To disable the station lock, choose Disable Station Lock. To immediately lock the station,
select Programs, then Lock Station Now. If a password is forgotten, contact Graphic
Products at 800.788.5572.
7.5 Installing an External Pointing Device
Toro supports most USB-compatible pointing devices, such as ordinary computer mice
and trackballs. To install a pointing device, plug it into an available USB-A port on your
Toro. The system will automatically recognize the new device.
7.6 Recovering Templates
Toro retains a backup copy of all original manufacturer-supplied label templates. If
changes were made to an original template but the unchanged one is needed, follow
these steps to replace the edited template with the original:
To Next Page
Loading...
