12
The following power-up conditions on the system status LED are abnormal:
LED not lit—Check the power supply and cabling. If power is available and the LED
stays off, call DVTel Technical Support for assistance.
Steady red LED—There is an internal error that prevents the device from starting
normally. Power down the device, wait 30 seconds, then power it up. If the
condition persists, call DVTel Technical Support.
Flashing green (3 sec.
intervals)
The firmware has started, but the device is
not connected to the network.
Flashing green (1 sec.
intervals)
The firmware has started, the device is
connected to the network, but no video data is
transmitted.
Flashing green
(0.2 sec. intervals)
The firmware has started, the device is
connected to the network, and video data is
transmitted.
Flashing green-red
(1 sec. intervals)
The device is undergoing a firmware update.
Flashing red (0.1 sec.
intervals)
The device is being identified.
Condition Indication
To Next Page
Loading...
