DVTEL 9540 - System Time; HTTP (Webserver)

22
 VSIP Multicast IP Address—The IP address used by the unit to listen for VSIP
queries. The default multicast address is 224.16.32.1 and should not be changed.
 VSIP Discovery IP Address—The IP address used by the unit to make its presence
known using the broadcast method. The broadcast address is 255.255.255.255.
 VSIP Unit Name—The name of the unit.
System Time
You can set the following system time parameters:
 NTP Server Usage—To enable or disable the use of the network time protocol
(NTP) to get the current time. NTP uses GMT to synchronize device clock time.
 NTP Server IP Address—The IP address of the NTP server from which the unit
should get the current time.
 NTP Server IP Port—The IP port of the NTP server. Default is 123.
 Local Time Offset—The offset in minutes from the GMT time of the current time
zone (for instance, the offset for the Eastern Standard Time is -300 minutes).
HTTP (Webserver)
A series of parameters can be configured for the web interface itself:
Note: If you change any of these parameters, you must refresh the web page.
 HTTP Server IP Port—The port number of the HTTP server. The default is 80.
 HTTP Streaming Method—The protocol used for transmitting video.