6
Inserting the Battery Pack
The battery pack included with your label
maker comes partially charged. You do not
need to charge the battery pack before
using your label maker for the first time.
To insert the battery pack
1 Slide the battery compartment cover
away from the label maker. See Figure 2.
2 Insert the battery pack into the battery compartment.
3 Replace the battery compartment cover.
NOTE Remove the battery pack if the label maker will not be used for a long
period of time.
Recharging the Battery Pack
A power adapter is included with your label maker for recharging the
battery pack.
NOTE The power adapter is only used for recharging the battery pack; the
power adapter cannot be used to power the label maker.
To recharge the battery pack
1 Plug the power adapter into the power connector on the top of the
label maker.
2 Plug the other end of the power adapter into a power outlet.
To Next Page
Loading...
