1. Insert the SSD to the connector CN1900 on the System Board
slantwise.
2. Push down the SSD and secure it with the screw.
Figure 4-8 Installing the SSD
4.14
Fan
4.14.1
Removing the Fan
To remove the Fan, follow the steps below.
1. Disconnect the Fan harness from the connector CN3380 on the
System Board.
2. Remove the following screws and the Fan from the Cover Assembly.
To avoid damage, always hold the SSD only by its sides.
To prevent the SSD from being distorted when installing the SSD pack into the
computer, do not press the center of the SSD pack. Always hold the SSD pack by its
sides.
To Next Page
Loading...
Need help?
General