Dynapac LH700 - Driving Safety Guidelines; Operating Near Edges; Driving on Slopes

7LH700 ILH700EN1
SAFETY WHEN DRIVING
When driving near an edge, at least two thirds of the
plate must be on firm solid ground.
If the machine tips over, switch off the en-
gine before attempting to lift the machine.
Driving near an edge
At least
2/3
Machine location when operating on edges
L000262A
Max 20°
or 36%
Driving on slopes
L000264A
Make sure that the work site is safe. Wet and loose
earth reduces manoeuvrability especially on sloping
ground. Always observe particular caution on sloping
and uneven terrain.
Where possible, avoid all driving across a
slope. Instead, drive up and down on sloping
ground.
Never work on slopes that are greater than the capabil-
ity of the machine. Maximum slope of the machine in
operation is 20° (depending on condition of the ground).
Be careful when driving on slopes. Remember that
loose ground, vibration switched ON, and driving speed
can all cause the machine to topple even on a smaller
slope than specified here.
Never leave the machine unattended with the
engine running.
WARNING
WARNING
WARNING