Dynapac LP8500 - MAINTENANCE - SERVICE POINTS; Daily (10-hour) service checks

26
LP8500 ILP8500EN1
On new machines, the engine valve clearance must be checked and if necessary ad-
justed after 25 hours of operation. Also inspect the engine spacer bolts after 25 hours of
operation. Change the engine oil and filter after the first 50 hours of operation, and the
hydraulic filter and hydraulic fluid after 150 hours of operation.
Item in fig. Maintenance see page Comments
1 Check the Engine Oil Level 28
2 Check Hydraulic Oil Level 28
3 Check Fuel Tank Level 28
4 Check Air Cleaner evacuator valve 28
5 Check Scraper adjustment 28
Check all bolts and nuts for thigtness
Every 10 hours (Daily)
Fig 1
10
5
372
Study the engine instruction manual and follow the maintenance instructions.
12 1911
6
8
MAINTENANCE – SERVICE POINTS
L000363D
1. Engine Oil
2. Tank for Hydraulic Oil
3. Fuel Tank
4. Air Cleaner evacuator valve
5. Scraper
6. Engine Oil Filter
7. Hydraulic Filter
8. Fuel Filter
9. Muffler
10. Battery
11. Engine cooling system
12. Fuel Filter (dewatering)
CAUTION
CAUTION
4