20
LP8500 ILP8500EN1
1. Stop the vibration, inactivated vibrationswitch (6) in
neutral mode.
2. Set the speed switch (2) to “low” (tortoise).
3. Set the engine speed to low.
4. Let the engine idle a couple of minutes.
5. Push the start/stop switch (10) backward.
6. The buzzer sounds when the engine stops.
7. Open the rear servicecover and turn back the
battery disconnecter (17) so that the beeper is
silenced.
8. Press the emergency stop button (8) to switch off
the transmitter; the green indicator lamp goes out.
9. Put the transmitter in transport mode in the
machine, or keep it in a safe place.
10. Charge the transmitter battery after the day’s work
so that a fully-charged battery is always available.
Always store the transmitter securely to
prevent unauthorized starting of the ma-
chine.
OPERATION – RADIO REMOTE CONTROL UNIT
The machine will immediately stop when
the emergency stop knob on the machine
is pressed. Make sure that the emergency
stops is always in working order.
The machine stops immediately when you
release the joystick. Make sure that the
joystick is working and that it returns to
zero mode on being released. The machine
stops immediately when the on/off switch
on the transmitter is turned off.
WARNING
WARNING
Transmitter
Shut off the machine
13. Transmitter
14. Antenna
15. Emergency stop knob
16. Receiver
17. Master switch
18. Buzzer
2. Speed switch, High/Low
3. Engine speed
5. Joystick
6. Vibrationswitch, direction
7. Transmitter indicator, On
8. Emergency stop button/transmitter on/off
9. Low-battery indicator
10. Start/Stop switch, engine
11. Push button to alter frequency/browse
through values on the display
L000338A
23 567891011
1315
18
16
17
14
L000628A
To Next Page
Loading...
