7
LP8500 ILP8500EN1
SAFETY WHEN DRIVING
Max 20°
or 36%
Slopes
Driving on slopes
L000343B
Max 20°
or 36%
L000342B
Tipping angle on side slopes
When driving near an edge, at least two thirds of the
plate must be on firm solid ground.
If the machine tips over, switch off the
engine before attempting to lift the ma-
chine.
Make sure that the work site is safe. Wet and loose
earth reduces manoeuvrability especially on sloping
ground. Always observe particular caution on sloping
and uneven terrain.
Where possible, avoid all driving across a
slope. Instead, drive up and down on slop-
ing ground.
Never work on slopes that are greater than the capabil-
ity of the machine. Maximum slope of the machine in
operation is 20° (depending on condition of the ground).
The tilting angle is measured on a hard, level surface
with the machine stationary. Vibration switched OFF
and all tanks full. Remember that loose ground, vibra-
tion switched ON, and driving speed can all cause the
machine to topple even on a smaller slope than speci-
fied here.
Never leave the machine unattended with
the engine running.
Driving near an edge
At least
2/3
Machine location when operating
on edges
L000341B
WARNING
WARNING
WARNING
To Next Page
Loading...
Need help?
General