29
LP8500 ILP8500EN1
Warning of scalding due to hot engine.
Always make sure that the engine is cold.
1. Remove all air guides.
2. Dry-clean all air guides, as well as the entire cooling
air region including cylinder heads, cylinders and
flywheel fins, and blow out with compressed air.
Check and set the engines tappet clearance
See engine instruction book.
Warning of scalding due to hot oil.
1. Clean the area around the filter cover (5) unscrew it,
and replace the filter element (6) the filter element is
one time type and should be disposed in an environ-
mentally way.
2. Place the new filter in the chamber and check
condition of the o-ring (7) on the cover.
3. Screw back the cover and check that there is no
leakage.
Pls also read engine instruction book.
Warning of scalding due to hot oil.
1. Only drain off engine oil when the engine is warm.
2. Unscrew oil drain plug (1) and drain off oil com-
pletely.
3. Refit the oil drain plug (1) and thigten.
4. Using a band wrench, loosen the lub.-oil filter (2) and
remove. Always replace the lub.-oil filter.
5. Clean the sealing surface (3) thoroughly.
6. Lightly oil the sealing ring (4) of the new lub.-oil filter.
7. Insert lub.-oil filter P/N 238380 and thighten by hand.
8. Fill up with engine oil.
9. After a short test run, check that the lub.-oil filter is
sealed, tighten if necessary.
5
1
2
3
4
Replace the Engine Oil and
Engine Oil Filter
Check and clean the engine
cooling air system
Replace hydraulic oil filter
MAINTENANCE – EVERY 250 HOURS
L000373A
L000370A
L000371A
L000372A
WARNING
WARNING
WARNING
To Next Page
Loading...