F 31 2
Danger of being pulled in by rotating or conveying
vehicle parts
Rotating or conveying vehicle parts can cause severe or
fatal injuries!
- Do not enter the danger zone.
- Do not reach into rotating or conveying parts.
- Only wear close-fitting clothing.
- Comply with the warning and information signs on the
vehicle.
- Stop the engine and remove the ignition key before any
maintenance work.
- Comply with all further information in these instructions
and in the safety manual.
Danger from heavy loads
Lowering vehicle parts may cause injuries!
- When the vehicle is parked and during maintenance and
transport, close both halves of the hopper and fit the cor-
responding hopper transport safeguards.
- When the vehicle is parked and during maintenance and
transport, raise the screen and fit the corresponding
screed transport safeguards.
- Ensure that opened hoods and covering parts are locked
properly.
- Comply with all further information in these instructions
and in the safety manual.
Hot surfaces!
Surfaces including those behind covering parts, together
with combustion fuels from the engine or screed heater can
be very hot and cause injuries!
- Wear your personal safety gear.
- Do not touch hot parts of the vehicle.
- Only perform maintenance and repair work after the
vehicle has cooled down.
- Comply with all further information in these instructions
and in the safety manual.
To Next Page
Loading...
