Dynapac SD2550C - Page 8

6
E11 Set-up and modification .........................................................1
1 Special notes on safety ..............................................................................1
2 Distribution auger .......................................................................................2
2.1 Height adjustment ......................................................................................2
Grain sizes up to 16 mm ........................................................................2
Grain sizes > 16 mm ..............................................................................2
2.2 Mechanical adjustment with ratchet (o) ......................................................3
2.3 Hydraulic adjustment (o) ............................................................................3
2.4 Height adjustment for large working widths / with brace ............................4
3 Auger extension .........................................................................................6
3.1 Mounting extension parts ...........................................................................7
Mounting the material shaft and auger extension ..................................7
Mounting the outer auger bearing ..........................................................8
Mounting the auger end bearing ............................................................9
3.2 Auger extension chart ..............................................................................10
Auger upgrading, working width 3.14 m ...............................................12
Auger upgrading, working width 3.78 m ...............................................12
Auger upgrading, working width 4.42 m ...............................................12
Auger upgrading, working width 5.06 m ...............................................13
Auger upgrading, working width 5.70 m ...............................................13
Auger upgrading, working width 6.34 m ...............................................14
Auger upgrading, working width 6.98 m ...............................................15
Auger upgrading, working width 7.62 m ...............................................16
Auger upgrading, working width 8.26 m ...............................................17
Auger upgrading, working width 8.90 m ...............................................18
Auger upgrading, working width 9.54 m ...............................................19
Auger upgrading, working width 10.18 m .............................................20
Auger upgrading, working width 10.82 m .............................................21
Auger upgrading, working width 11.46 m .............................................22
Auger upgrading, working width 12.10 m .............................................23
Auger upgrading, working width 12.74 m .............................................24
3.3 Mounting the auger brace ........................................................................25
3.4 Aligning the auger ....................................................................................27
3.5 Material shaft, hinged ...............................................................................29
3.6 Hopper scraper .........................................................................................30
3.7 Crossbeam guide .....................................................................................31
4 Offsetting the screed ................................................................................32
5 Levelling ...................................................................................................33
5.1 Slope controller ........................................................................................33
5.2 Mounting the sensor arm ..........................................................................34
5.3 Mounting the grade control system ..........................................................34
5.4 Setting up the sensor arm ........................................................................35
5.5 Big ski 9 m, big ski 13 m ..........................................................................36
Mounting the big ski bracket on the crossbeam ...................................38
Mounting the swivel arms .....................................................................39
Mounting the centre element ................................................................40
Extending the big ski ............................................................................41
Mounting the sensor bracket ................................................................42
Mounting and aligning the sensors ......................................................43