Tower ESS User Manual
20
©Dyness reserves the copyright of this document.
The battery system is a high voltage DC system. Ensure that the grounding surface of
Tower is stable and reliable.
Please confirm that the battery system is switched off before connecting. Electric shock
and damage to the inverter may be caused if the battery is connected directly without
being switched off.
Otherwise, the system cannot work properly. The voltage of the battery is too high, please
pay attention to self-protection during measurement.
A single battery module weighs 41kg. It is necessary to install battery modules with
helpers if no lifting equipment is available, even more so if the battery modules are
installed higher up.
Double check all the power and communication cables. Make sure that the voltage of the
inverter is at the same level as the battery system.
Switch on the inverter, and make sure that all power equipment is working normally.
Start the battery system. See Table 3-2 Battery system self-test step 2.
To Next Page
Loading...
